mFluor™ Violet 590 SE

mFluor™ dyes are developed for multicolor flow cytometry-focused applications. These dyes have large Stokes Shifts, and can be well excited by the laser lines of flow cytometers (e.g., 405 nm, 488 nm and 633 nm). mFluor™ Violet dyes are optimized to be excited with a violet laser at 405 nm. AAT Bioquest offers the largest collection of fluorescent dyes that are excited by violet laser. mFluor™ Violet 590 dyes have fluorescence excitation and emission maxima of ~405 nm and ~590 nm respectively. These spectral characteristics make them a unique color for flow cytometry application. mFluor™ Violet 590 SE is reasonably stable and shows good reactivity and selectivity with protein amino groups. mFluor™ Violet 590 SE provides a convenient tool to label monoclonal, polyclonal antibodies or other proteins (>10 kDa) for flow cytometric applications with the violet laser excitation.

Example protocol

PREPARATION OF STOCK SOLUTIONS

Unless otherwise noted, all unused stock solutions should be divided into single-use aliquots and stored at -20 °C after preparation. Avoid repeated freeze-thaw cycles.

1. Protein stock solution (Solution A)

Mix 100 µL of a reaction buffer (e.g., 1 M sodium carbonate solution or 1 M phosphate buffer with pH ~9.0) with 900 µL of the target protein solution (e.g. antibody, protein concentration >2 mg/mL if possible) to give 1 mL protein labeling stock solution.
Note     The pH of the protein solution (Solution A) should be 8.5 ± 0.5. If the pH of the protein solution is lower than 8.0, adjust the pH to the range of 8.0-9.0 using 1 M sodium bicarbonate solution or 1 M pH 9.0 phosphate buffer.
Note     The protein should be dissolved in 1X phosphate buffered saline (PBS), pH 7.2-7.4. If the protein is dissolved in Tris or glycine buffer, it must be dialyzed against 1X PBS, pH 7.2-7.4, to remove free amines or ammonium salts (such as ammonium sulfate and ammonium acetate) that are widely used for protein precipitation.
Note     Impure antibodies or antibodies stabilized with bovine serum albumin (BSA) or gelatin will not be labeled well. The presence of sodium azide or thimerosal might also interfere with the conjugation reaction. Sodium azide or thimerosal can be removed by dialysis or spin column for optimal labeling results.
Note     The conjugation efficiency is significantly reduced if the protein concentration is less than 2 mg/mL. For optimal labeling efficiency the final protein concentration range of 2-10 mg/mL is recommended.

2. mFluor™ Violet 590 SE stock solution (Solution B)

Add anhydrous DMSO into the vial of mFluor™ Violet 590 SE to make a 10 mM stock solution. Mix well by pipetting or vortex.
Note Prepare the dye stock solution (Solution B) before starting the conjugation. Use promptly. Extended storage of the dye stock solution may reduce the dye activity. Solution B can be stored in freezer for two weeks when kept from light and moisture. Avoid freeze-thaw cycles.

SAMPLE EXPERIMENTAL PROTOCOL

This labeling protocol was developed for the conjugate of Goat anti-mouse IgG with mFluor™ Violet 590 SE. You might need further optimization for your particular proteins.
Note Each protein requires distinct dye/protein ratio, which also depends on the properties of dyes. Over labeling of a protein could detrimentally affects its binding affinity while the protein conjugates of low dye/protein ratio gives reduced sensitivity.

Run conjugation reaction

Use 10:1 molar ratio of Solution B (dye)/Solution A (protein) as the starting point: Add 5 µL of the dye stock solution (Solution B, assuming the dye stock solution is 10 mM) into the vial of the protein solution (95 µL of Solution A) with effective shaking. The concentration of the protein is ~0.05 mM assuming the protein concentration is 10 mg/mL and the molecular weight of the protein is ~200KD.
Note We recommend to use 10:1 molar ratio of Solution B (dye)/Solution A (protein). If it is too less or too high, determine the optimal dye/protein ratio at 5:1, 15:1 and 20:1 respectively.
Continue to rotate or shake the reaction mixture at room temperature for 30-60 minutes.

Purify the conjugation

The following protocol is an example of dye-protein conjugate purification by using a Sephadex G-25 column.

Prepare Sephadex G-25 column according to the manufacture instruction.
Load the reaction mixture (From "Run conjugation reaction") to the top of the Sephadex G-25 column.
Add PBS (pH 7.2-7.4) as soon as the sample runs just below the top resin surface.
Add more PBS (pH 7.2-7.4) to the desired sample to complete the column purification. Combine the fractions that contain the desired dye-protein conjugate.
Note For immediate use, the dye-protein conjugate need be diluted with staining buffer, and aliquoted for multiple uses.
Note For longer term storage, dye-protein conjugate solution need be concentrated or freeze dried.

Spectrum

Open in Advanced Spectrum Viewer

Product family

Name	Excitation (nm)	Emission (nm)	Extinction coefficient (cm ^-1 M ^-1)	Quantum yield	Correction Factor (260 nm)	Correction Factor (280 nm)
mFluor™ Violet 450 SE	406	445	35000¹	0.81¹	0.338	0.078
mFluor™ Violet 510 SE	412	505	25000¹	0.86¹	0.464	0.366
mFluor™ Violet 540 SE	402	535	18000¹	0.21¹	1.326	0.543
mFluor™ Violet 500 SE	410	501	25000¹	0.81¹	0.769	0.365
mFluor™ Violet 610 SE	594	612	90000¹	0.3¹	0.532	0.66
mFluor™ Blue 590 SE	569	589	81000¹	0.15¹	0.671	0.406
mFluor™ Violet 550 SE	527	550	90000¹	0.31¹	0.474	0.306
mFluor™ Violet 505 SE	393	504	40000¹	0.45¹	0.888	0.403
mFluor™ Violet 545 SE	393	543	20000¹	0.15¹	1.08	0.496
mFluor™ Violet 530 SE	393	543	20000¹	-	-	-
mFluor™ Violet 480 SE	404	475	40,000	-	1.23	0.6570
Show More (2)

References

View all 46 references: Citation Explorer

Azo dyes decolorization under high alkalinity and salinity conditions by Halomonas sp. in batch and packed bed reactor.
Authors: Montañez-Barragán, B and Sanz-Martín, J L and Gutiérrez-Macías, P and Morato-Cerro, A and Rodríguez-Vázquez, R and Barragán-Huerta, B E
Journal: Extremophiles : life under extreme conditions (2020): 239-247

Adsorption of Remazol Brilliant Violet-5R Textile Dye from Aqueous Solutions by Using Eggshell Waste Biosorbent.
Authors: Rápó, Eszter and Aradi, László Előd and Szabó, Ábel and Posta, Katalin and Szép, Robert and Tonk, Szende
Journal: Scientific reports (2020): 8385

Process optimization and filtration performance of an anaerobic dynamic membrane bioreactor treating textile wastewaters.
Authors: Yurtsever, Adem and Basaran, Erkan and Ucar, Deniz
Journal: Journal of environmental management (2020): 111114

Simultaneous Polychromatic Immunofluorescent Staining of Tissue Sections and Consecutive Imaging of up to Seven Parameters by Standard Confocal Microscopy.
Authors: Schmidt, Alfonso J and Mayer, Johannes U and Wallace, Paul K and Ronchese, Franca and Price, Kylie M
Journal: Current protocols in cytometry (2019): e64

Remediation of complex remazol effluent using biochar derived from green seaweed biomass.
Authors: Gokulan, Ravindiran and Prabhu, Ganapathy Ganesh and Jegan, Josephraj
Journal: International journal of phytoremediation (2019): 1179-1189

Page updated on November 24, 2024

Ordering information

Price
Unit size
Catalog Number	1155
Quantity

Add to cart

Additional ordering information

Telephone	1-800-990-8053
Fax	1-800-609-2943
Email	sales@aatbio.com
International	See distributors
Bulk request	Inquire
Custom size	Inquire
Technical Support	Contact us
Purchase order	Send to sales@aatbio.com
Shipping	Standard overnight for United States, inquire for international

Request quotation

Physical properties

Molecular weight	1277.89
Solvent	DMSO

Spectral properties

Absorbance (nm)	563
Correction Factor (260 nm)	0.632
Correction Factor (280 nm)	0.329
Extinction coefficient (cm ^-1 M ^-1)	90000¹
Excitation (nm)	564
Emission (nm)	591
Quantum yield	0.22¹

Storage, safety and handling

H-phrase	H303, H313, H333
Hazard symbol	XN
Intended use	Research Use Only (RUO)
R-phrase	R20, R21, R22
Storage	Freeze (< -15 °C); Minimize light exposure
UNSPSC	12171501